Flat 64 Loom Building
1, Harrison Street
- Property type
- Total floor area
72 square metres
Rules on letting this property
Properties can be let if they have an energy rating from A to E.
You can read guidance for landlords on the regulations and exemptions.
Breakdown of property’s energy performance
This section shows the energy performance for features of this property. The assessment does not consider the condition of a feature and how well it is working.
Each feature is assessed as one of the following:
- very good (most efficient)
- very poor (least efficient)
When the description says “assumed”, it means that the feature could not be inspected and an assumption has been made based on the property’s age and type.
||Average thermal transmittance 0.26 W/m²K
||High performance glazing
||Room heaters, electric
|Main heating control
||Programmer and appliance thermostats
||Electric immersion, standard tariff
||Low energy lighting in all fixed outlets
||Air permeability 3.7 m³/h.m² (as tested)
||(other premises above)
||(other premises below)
Low and zero carbon energy sources
Low and zero carbon energy sources release very little or no CO2. Installing these sources may help reduce energy bills as well as cutting carbon emissions. The following low or zero carbon energy sources are installed in this property:
Primary energy use
The primary energy use for this property per year is 115 kilowatt hours per square metre (kWh/m2).
What is primary energy use?
Primary energy use is a measure of the energy required for lighting, heating and hot water in a property. The calculation includes:
- the efficiency of the property’s heating system
- power station efficiency for electricity
- the energy used to produce the fuel and deliver it to the property
Environmental impact of this property
This property’s current environmental impact rating is B. It has the potential to be B.
Properties are rated in a scale from A to G based on how much carbon dioxide (CO2) they produce.
Properties with an A rating produce less CO2 than G rated properties.
- An average household produces
- 6 tonnes of CO2
- This property produces
- 1.4 tonnes of CO2
- This property’s potential production
- 1.4 tonnes of CO2
By making the recommended changes, you could reduce this property’s CO2 emissions by 0.0 tonnes per year. This will help to protect the environment.
Environmental impact ratings are based on assumptions about average occupancy and energy use. They may not reflect how energy is consumed by the people living at the property.
Improve this property’s energy performance
Estimated energy use and potential savings
- Estimated yearly energy cost for this property
- Potential saving
The estimated cost shows how much the average household would spend in this property for heating, lighting and hot water. It is not based on how energy is used by the people living at the property.
The potential saving shows how much money you could save if you complete each recommended step in order.
For advice on how to reduce your energy bills visit Simple Energy Advice.
Heating use in this property
Heating a property usually makes up the majority of energy costs.
Estimated energy used to heat this property
676 kWh per year
1670 kWh per year
Potential energy savings by installing insulation
The assessor did not find any opportunities to save energy by installing insulation in this property.
Contacting the assessor and accreditation scheme
This EPC was created by a qualified energy assessor.
If you are unhappy about your property’s energy assessment or certificate, you can complain to the assessor directly.
If you are still unhappy after contacting the assessor, you should contact the assessor’s accreditation scheme.
Accreditation schemes are appointed by the government to ensure that assessors are qualified to carry out EPC assessments.
Assessor contact details
- Assessor’s name
Accreditation scheme contact details
- Accreditation scheme
Elmhurst Energy Systems Ltd
- Assessor ID
01455 883 250
- Assessor’s declaration
No related party
- Date of assessment
18 December 2019
- Date of certificate
18 December 2019
- Type of assessment
Show information about the SAP
SAP (Standard Assessment Procedure) is a method used to assess and compare the energy and environmental performance of properties in the UK. It uses detailed information about the property’s construction to calculate energy performance.
This type of assessment must be carried out on all new properties built after 1 April 2008 in England and Wales, and 30 September 2008 in Northern Ireland.
Other certificates for this property
If you are aware of previous certificates for this property and they are not listed here, please contact us at firstname.lastname@example.org or call our helpdesk on 020 3829 0748.
There are no related certificates for this property.