Energy performance certificate (EPC)


Energy rating

D

10d Calthorpe Mansions
Calthorpe Road
Edgbaston
BIRMINGHAM
B15 1QS

15 September 2031

3339-7621-0000-0936-9292

Property type
Top-floor flat
Total floor area
91 square metres

Rules on letting this property

Properties can be rented if they have an energy rating from A to E.

If the property is rated F or G, it cannot be let, unless an exemption has been registered. You can read guidance for landlords on the regulations and exemptions.

Energy efficiency rating for this property

This property’s current energy rating is D. It has the potential to be C.

See how to improve this property’s energy performance.

Energy efficiency chart This property’s current energy rating is D with a score of 59. It has a potential energy rating of C with a score of 72.

The graph shows this property’s current and potential energy efficiency.

Properties are given a rating from A (most efficient) to G (least efficient).

Properties are also given a score. The higher the number the lower your fuel bills are likely to be.

For properties in England and Wales:

  • the average energy rating is D
  • the average energy score is 60

Breakdown of property’s energy performance

This section shows the energy performance for features of this property. The assessment does not consider the condition of a feature and how well it is working.

Each feature is assessed as one of the following:

  • very good (most efficient)
  • good
  • average
  • poor
  • very poor (least efficient)

When the description says “assumed”, it means that the feature could not be inspected and an assumption has been made based on the property’s age and type.

Feature Description Rating
Wall Cavity wall, as built, no insulation (assumed) Poor
Wall Solid brick, as built, no insulation (assumed) Very poor
Roof Flat, limited insulation Poor
Window Fully double glazed Average
Main heating Community scheme Good
Main heating control Flat rate charging, TRVs Average
Hot water Community scheme Good
Lighting Low energy lighting in all fixed outlets Very good
Floor (another dwelling below) N/A
Secondary heating None N/A

Primary energy use

The primary energy use for this property per year is 320 kilowatt hours per square metre (kWh/m2).

What is primary energy use?

Primary energy use is a measure of the energy required for lighting, heating and hot water in a property. The calculation includes:

  • the efficiency of the property’s heating system
  • power station efficiency for electricity
  • the energy used to produce the fuel and deliver it to the property

Additional information

Additional information about this property:

  • Cavity fill is recommended

Environmental impact of this property

This property's current environmental impact rating is E. It has the potential to be D.

Properties are rated in a scale from A to G based on how much carbon dioxide (CO2) they produce.

Properties with an A rating produce less CO2 than G rated properties.

An average household produces
6 tonnes of CO2
This property produces
5.2 tonnes of CO2
This property’s potential production
3.3 tonnes of CO2

By making the recommended changes, you could reduce this property’s CO2 emissions by 1.9 tonnes per year. This will help to protect the environment.

Environmental impact ratings are based on assumptions about average occupancy and energy use. They may not reflect how energy is consumed by the people living at the property.

How to improve this property’s energy performance

Potential energy rating

C

Making any of the recommended changes will improve this property’s energy efficiency.

If you make all of the recommended changes, this will improve the property’s energy rating and score from D (59) to C (72).

What is an energy rating?
An energy rating shows a property’s energy efficiency.

Properties are given a rating from A (most efficient) to G (least efficient).

Properties are also given a score. The higher this number, the lower your CO2 emissions are likely to be.

Recommendation 1: Flat roof or sloping ceiling insulation

Flat roof or sloping ceiling insulation

Typical installation cost
£850 - £1,500
Typical yearly saving
£99
Potential rating after carrying out recommendation 1
band-d 63 | D

Recommendation 2: Cavity wall insulation

Cavity wall insulation

Typical installation cost
£500 - £1,500
Typical yearly saving
£152
Potential rating after carrying out recommendations 1 and 2
band-c 69 | C

Recommendation 3: Internal or external wall insulation

Internal or external wall insulation

Typical installation cost
£4,000 - £14,000
Typical yearly saving
£66
Potential rating after carrying out recommendations 1 to 3
band-c 72 | C

Estimated energy use and potential savings

Estimated yearly energy cost for this property
£993
Potential saving
£317

The estimated cost shows how much the average household would spend in this property for heating, lighting and hot water. It is not based on how energy is used by the people living at the property.

The estimated saving is based on making all of the recommendations in how to improve this property’s energy performance.

For advice on how to reduce your energy bills visit Simple Energy Advice.

Heating use in this property

Heating a property usually makes up the majority of energy costs.

Estimated energy used to heat this property

Space heating
13322 kWh per year
Water heating
2258 kWh per year
Potential energy savings by installing insulation
Type of insulation Amount of energy saved
Cavity wall insulation 2714 kWh per year
Solid wall insulation 1158 kWh per year

You might be able to receive Renewable Heat Incentive payments. This will help to reduce carbon emissions by replacing your existing heating system with one that generates renewable heat. The estimated energy required for space and water heating will form the basis of the payments.

Contacting the assessor and accreditation scheme

This EPC was created by a qualified energy assessor.

If you are unhappy about your property’s energy assessment or certificate, you can complain to the assessor directly.

If you are still unhappy after contacting the assessor, you should contact the assessor’s accreditation scheme.

Accreditation schemes are appointed by the government to ensure that assessors are qualified to carry out EPC assessments.

Assessor contact details

Assessor’s name
Jonathan Daly
Telephone
07985 696182

Accreditation scheme contact details

Accreditation scheme
Elmhurst Energy Systems Ltd
Assessor ID
EES/002297
Telephone
01455 883 250

Assessment details

Assessor’s declaration
No related party
Date of assessment
16 September 2021
Date of certificate
16 September 2021
Type of assessment
RdSAP
RdSAP (Reduced data Standard Assessment Procedure) is a method used to assess and compare the energy and environmental performance of properties in the UK. It uses a site visit and survey of the property to calculate energy performance.

This type of assessment can be carried out on properties built before 1 April 2008 in England and Wales, and 30 September 2008 in Northern Ireland. It can also be used for newer properties, as long as they have a previous SAP assessment, which uses detailed information about the property’s construction to calculate energy performance.

Other certificates for this property

If you are aware of previous certificates for this property and they are not listed here, please contact us at mhclg.digital-services@communities.gov.uk or call our helpdesk on 020 3829 0748.

Certificate number
8351-6826-6270-5364-9026
Expired on
25 June 2019