The graph shows this property’s current and potential energy efficiency.
Properties are given a rating from A (most efficient) to G (least efficient).
Properties are also given a score. The higher the number the lower your fuel bills are likely to be.
For properties in England and Wales:
the average energy rating is D
the average energy score is 60
Breakdown of property’s energy performance
This section shows the energy performance for features of this property. The assessment does not consider the condition of a feature and how well it is working.
Each feature is assessed as one of the following:
very good (most efficient)
good
average
poor
very poor (least efficient)
When the description says “assumed”, it means that the feature could not be inspected and an assumption has been made based on the property’s age and type.
Feature
Description
Rating
Wall
Solid brick, with internal insulation
Very good
Wall
Solid brick, as built, no insulation (assumed)
Very poor
Roof
Pitched, 300 mm loft insulation
Very good
Roof
Flat, no insulation (assumed)
Very poor
Window
Fully double glazed
Average
Main heating
Boiler and radiators, mains gas
Good
Main heating control
Programmer, TRVs and bypass
Average
Hot water
From main system
Good
Lighting
Low energy lighting in 67% of fixed outlets
Good
Floor
(other premises below)
N/A
Secondary heating
None
N/A
Primary energy use
The primary energy use for this property per year is 283 kilowatt hours per square metre (kWh/m2).
What is primary energy use?
Primary energy use is a measure of the energy required for lighting, heating and hot water in a property. The calculation includes:
the efficiency of the property’s heating system
power station efficiency for electricity
the energy used to produce the fuel and deliver it to the property
Environmental impact of this property
This property’s current environmental impact rating is D. It has the potential to be C.
Properties are rated in a scale from A to G based on how much carbon dioxide (CO2) they produce.
Properties with an A rating produce less CO2 than G rated properties.
An average household produces
6 tonnes of CO2
This property produces
4.1 tonnes of CO2
This property’s potential production
2.9 tonnes of CO2
By making the recommended changes, you could reduce this property’s CO2 emissions by 1.2 tonnes per year. This will help to protect the environment.
Environmental impact ratings are based on assumptions about average occupancy and energy use. They may not reflect how energy is consumed by the people living at the property.
Improve this property’s energy performance
Potential energy rating
C
By following our step by step recommendations you could reduce this property’s energy use and potentially save money.
Carrying out these changes in order will improve the property’s energy rating and score from D (63) to C (72).
Do I need to follow these steps in order?
Yes. Each step builds on the one before it so you can save the most energy.
For example, it’s more energy efficient to insulate your home before you buy a new boiler. A well insulated home will lose less heat so you do not have to run your boiler as often.
Step 1: Internal or external wall insulation
Internal or external wall insulation
Typical installation cost
£4,000 - £14,000
Typical yearly saving
£96
Potential rating after completing step 1
band-d
66 | D
Step 2: Low energy lighting
Low energy lighting
Typical installation cost
£10
Typical yearly saving
£15
Potential rating after completing steps 1 and 2
band-d
67 | D
Step 3: Heating controls (room thermostat)
Heating controls (room thermostat)
Typical installation cost
£350 - £450
Typical yearly saving
£38
Potential rating after completing steps 1 to 3
band-d
68 | D
Step 4: Replace boiler with new condensing boiler
Condensing boiler
Typical installation cost
£2,200 - £3,000
Typical yearly saving
£69
Potential rating after completing steps 1 to 4
band-c
71 | C
Step 5: Flue gas heat recovery device in conjunction with boiler
The estimated cost shows how much the average household would spend in this property for heating, lighting and hot water. It is not based on how energy is used by the people living at the property.
RdSAP (Reduced data Standard Assessment Procedure) is a method used to assess and compare the energy and environmental performance of properties in the UK. It uses a site visit and survey of the property to calculate energy performance.
This type of assessment can be carried out on properties built before 1 April 2008 in England and Wales, and 30 September 2008 in Northern Ireland. It can also be used for newer properties, as long as they have a previous SAP assessment, which uses detailed information about the property’s construction to calculate energy performance.
Green Deal Plan
Energy efficiency improvements were made to this property by a Green Deal Plan.
Before buying or renting this property, you should ask the property’s owner for a copy of the plan. You can also get a copy of the plan from the plan’s provider with the owner’s consent.
Cost of the plan
Plan charges:
are payable as part of the electricity bill
reduce as each improvement is paid off
Current charge
£329 per year
Estimated saving
£325 per year
Payment period start
8 April 2015
Payment period end
24 March 2039
Interest rate payable
fixed at 8.1% APR
This is the current charge, but the charge can change over time depending on the details of the plan. The plan can be paid off early, although extra costs may apply.
The estimated saving is based on:
the original Green Deal assessment
the improvements made by the plan
typical energy use for this type of property, using current energy prices
Increase loft insulation to 300mm: Knauf Earth Wool
Paid off 18 December 2038
internal wall insulation (150mm) to 50% of stone wall: BG Drilyner TL
If you are aware of previous certificates for this property and they are not listed here, please contact us at dluhc.digital-services@levellingup.gov.uk or call our helpdesk on 020 3829 0748.